Cisco 8800 Series User Manual page 183

Accessories
The following table describes the Cisco Headset 561 and 562 Headset buttons.
Table 13: Cisco Headset 561 and 562 Headset Buttons
Number Name
1
Power and Call button
2
Mute button
3
Volume button (
4 LED
Description
Use to power the headset on and off.
Press and hold for 4 seconds to power on/off the headset.
Incoming and active call management depends upon if you have one call
or multiple calls.
One call:
• Press once to answer incoming calls.
• Press once to put an active call on hold. Press again to retrieve the call
from hold.
• Press twice to reject an incoming call.
Multiple calls:
• Press once to put an active call on hold, and to answer a second
incoming call.
• Press once to put a current call on hold and press again to resume a
call.
• Press and hold for 2 seconds to end the current call and press again to
resume a held call.
• Press and hold for 2 seconds to end an active call, and to answer
another incoming call.
• Press twice to stay on a current call, and to reject a second incoming
call.
Toggle the microphone on and off. When Mute on the headset is enabled:
• The Mute
• The Mute
only)
Adjust the volume on your headset.
and )
Shows the headset status:
• Blinking red—Incoming call.
• Steady red—Active call.
• Flashing white every 6 seconds—The headset is paired and idle.
• Blinking white—Firmware upgrade is in process or the headset is
pairing with the base station.
Cisco IP Phone 8800 Series Multiplatform Phones User Guide
Cisco Headset 561 and 562 Buttons and LED
button on the phone lights up.
button on the headset base lights up. (For Multibase
169