Rcp Installation; Rcp Installation Recommendations; Rcp Installation Procedure; Rc100 - Kannad 406 AF-COMPACT Installation Manual

6. RCP installation

A. RCP Installation Recommendations
The RCP shall be installed in the cockpit. The RCP shall be readily accessible
from the pilot's normal seated position.
B. RCP Installation Procedure

(1)RC100

RC100 RCP is supplied as a kit
diagram).
Connection of RC100 requires a 3-wire bundle. A pin-to-pin wiring has to
be provided by the installer with AWG24 wires. Shielded wires are
recommended.
The wires are soldered to the switch pins, a resistor and LED legs. This
operation can be carried out before installation.
On the beacon side, the wires are soldered to a 12-pin plug that can be
either a standard "DIN12 connector" (P/N S1820514-03) or a connector
with an integrated serial memory module called "Programming Dongle"
(P/N S1820514-01).
Mount and install RCP
Refer to Figure 12: RC100 mounting diagram
NOTE: Legs of LED, pins of switch and resistor must be protected by heat
shrinkable sleeves.
- Place the front plate (1) on the instrument panel;
- Trace the centers of the two holes according to drilling mask supplied;
- Drill a hole Ø 8 mm for the LED mounting (2) (top of the panel);
- Drill a hole Ø6.5 mm for the switch (3) (bottom of the panel);
- Tear off protection from self-adhesive film;
- Stick the front plate (1) on the instrument panel;
- Install the LED mounting (2), with washer (2a) and nut (2b). Tighten nut;
- Solder the resistor (4) to pin 1 of Switch (3);
- Connect the anode (long leg) of LED (5) to pin 2 of switch (3);
- Make a strap between pin 3 of switch (3) and resistor (4);
- Connect wires to pin 2 of switch (3), the resistor (4) and the cathode
(short leg) of LED (5);
- Stuck the "identification label" (6) on the cable bundle near the switch;
- Insert the LED into the LED stand (7) taking care the flat part of the LED
INITIAL INSTALLATION MANUAL
KANNAD 406 AF-COMPACT / KANNAD 406 AF COMPACT ER
(Refer to Figure 12: RC100 mounting
PAGE: 14
SEP 16/2009