Rc200 - Kannad 406 AF-COMPACT Installation Manual

Connect RCP to ELT
Refer to Figure 15: Wiring of 2-wire bundle between RC102 and ELT
- Solder the DIN12 connector or Programming Dongle on the other side
of the bundle (pins K and M):
• Connect the wire from M of PCB (4) to pin M of DIN12 connector;
• Connect the wire from K of PCB (4) to pin K of DIN12 connector.
- Stuck the "CAUTION label" (9) on the cable bundle close to the DIN12
connector.
Figure 15: Wiring of 2-wire bundle between RC102 and ELT

(3) RC200

The RC200 is designed to be installed:
- either on the instrument panel with 4 screws (rivets bush recommended,
not supplied );
- or below the instrument panel with a special mounting tray (supplied).
Installation on the instrument panel
- Determine RC200 location on the instrument panel:
- Make a cutout on the instrument panel according to the Drilling mask
(Refer to RC200 Outline Dimensions and Driiling Mask, page
- Mark the 4 holes needed for the RC200 using the drilling mask or the
RC200 as a guide.
- Drill the 4 marked holes, diameter depending on rivets bush used.
- Install the RC200 by fitting it into the cutout.
- Secure the RC200 (4 rivets bush recommended).
Note: Rivets bush are not supplied.
INITIAL INSTALLATION MANUAL
KANNAD 406 AF-COMPACT / KANNAD 406 AF COMPACT ER
33).
PAGE: 20
SEP 16/2009