Transmitter And Bracket; Remote Control Panels (Rcp); Rc200 / Rc200-Nvg - Kannad 406 AF-COMPACT Installation Manual

B. Transmitter and bracket
The ELT must be installed into one of the approved mounting brackets.
It may be installed on its standard mounting bracket or on an Universal
Mounting Bracket to re-use existing drilling for retrofit.
Refer to Section 10. Compatibility list for KANNAD 406 AF-COMPACT System,
page 39 for Part Numbers of approved mounting brackets.
The bracket installed near the tail is designed to fix the ELT with a Velcro®
strap. This enables quick removal of the ELT for maintenance or exchange.
Figure 3: KANNAD 406 AF-COMPACT with Mounting Bracket
C. Remote Control Panels (RCP)
Refer to Section 10. Compatibility list for KANNAD 406 AF-COMPACT System,
page 39 for Part Numbers of approved RCPs.
The RCP must be installed in the cockpit to monitor and control the ELT status.

(1) RC200 / RC200-NVG

The RC200 or RC200 NVG remote control panel is connected to the ELT
via a 3-wire cable equipped with a DIN-12 connector or optional
programming dongle on the ELT side and a D-SUB Female 9 pins
connector on the other side.
Note: the 3-wire cable is not supplied.
INITIAL INSTALLATION MANUAL
KANNAD 406 AF-COMPACT / KANNAD 406 AF COMPACT ER
PAGE: 3
SEP 16/2009