Kannad 406 AF-COMPACT Installation Manual page 25

KANNAD 406 AF-COMPACT / KANNAD 406 AF COMPACT ER
Installation below the instrument panel
Refer to Figure 16: Installation of RC200 with mounting
Determine RC200 location below the instrument panel (be sure the
location meets the requirements established in RTCA-DO-204).
- According to the "area to be drilled" (1) of the mounting tray (3),
determine the location of the screws or rivets (2) used to secure the
mounting tray (3) to the instrument panel (4).
- Drill 2 holes on the mounting tray and on the instrument panel, diameter
depending on screws or rivets used.
- Secure the mounting tray (3) to the instrument panel (4).
- Secure the RC200 (5) to the mounting tray (3) with the 2 screws (6)
supplied (torque 0.8 Nm).
Figure 16: Installation of RC200 with mounting tray
Connection
Refer to Figure 17: Wiring of 3-wire bundle between RC200 and
Fabricate a 3-wire bundle (AWG 24, shielded preferred) long enough to
reach between the ELT installation location and the cockpit RCP location.
Slide heat-shrinkable sleeves on both sides of each wire.
On the ELT side:
- Solder the wires to the DIN12 connector supplied with the pack:
• solder the wires to pins G (RCP COMMON), A (RCP RESET) and J
(RCP LED) of the connector.
• Put heat-shrinkable sleeves to protect the pins
INITIAL INSTALLATION MANUAL
tray.
ELT.
PAGE: 21
SEP 16/2009