Rcp Installation - Kannad 406 AF-COMPACT Installation Manual

5. RCP installation

A. RCP Installation Recommendations
The RC200 shall be readily accessible from the pilot's normal seated position.
If possible, the RC200 should be installed in the cockpit in an area that is not
directly exposed to sun rays.
B. RCP Installation Procedure
The RC200 is designed to be installed:
• either on the instrument panel with 4 screws (rivets bush recommended,
not supplied );
• or below the instrument panel with a special mounting tray (supplied).
(1) Installation on the instrument panel
- Determine RC200 location on the instrument panel:
- Mark a cutout on the instrument panel according to the Drilling mask
(Refer to § 4. RC200 Drilling Mask, page
- Make the cutout.
- Mark the 4 holes needed for the RC200 using the drilling mask or the
RC200 as a guide.
- Drill the 4 marked holes, diameter depending on rivets bush used.
- Install the RC200 by fitting it into the cutout.
- Secure the RC200 (4 rivets bush recommended).
Note: Rivets bush are not supplied.
INSTALLATION MANUAL OPERATION MANUAL INSPECTION LOG
KANNAD 406 AF-COMPACT
504).
PAGE: 210
FEB 01/2008