Omron NX Series User Manual page 72

2 System Configuration
2-3
Network Configuration
You can make networks in the following layers with an NJ/NX-series Controller.
For details on communications networks that you can connect to, refer to the NJ/NX-series CPU Unit
Software User's Manual (Cat. No. W501).
FA Communications
Information
Level
EtherNet/IP
Built-in EtherNet/IP port
NJ-series
CPU Unit
CompoNet Master Unit
DeviceNet Unit
Field Level
CompoNet
MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 MS NS WORD NODE ADR 0 1 2 3 4 5 6 7
OUT OUT
CRT1-OD16 CRT1-OD16
REMOTE TERMINAL REMOTE TERMINAL
CompoNet slaves
Sysmac Studio
Between Control-
lers
Devices
Programmable Terminals
2-6
Software
Built-in EtherNet/IP port
NX-series
CPU Unit
Serial
Communications
Unit
RS-232C,
RS-422A/485
Serial communications devices
8 9 10 11 12 13 14 15 MS NS WORD NODE ADR 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
OUT
CRT1-OD16
REMOTE TERMINAL
General-purpose components or OMRON components
DeviceNet
DeviceNet slaves
Connection
NJ/NX-series Controller or CJ-series
PLC
Servo Drives, general-purpose
slaves and Vision Systems
Ethernet communications devices
Serial communications devices
DeviceNet slaves
CompoNet slaves
Sysmac FA Wireless
Studio LAN Unit
Built-in EtherCAT port
EtherCAT
EtherCAT
Servo Drives
Slave Terminal
RFID Systems
Use the built-in EtherNet/IP port.
Use the built-in EtherNet/IP port or a port on an
EtherNet/IP Unit.
Use the built-in EtherCAT port.
Use the built-in EtherNet/IP port or a port on an
EtherNet/IP Unit.
Mount a Serial Communications Unit
RS-232C port or RS-422A/485 ports.
Mount a DeviceNet Unit
Mount a CompoNet Master Unit
Net.
Use the built-in EtherNet/IP port or a port on an
EtherNet/IP Unit.
NX-series CPU Unit Hardware User's Manual (W535)
Programmable
Terminal
NJ/NX-series
CPU Unit
General-purpose
slaves Vision
Systems
EtherNet/IP
Robots
Connection method
*1
*1
*2
and use
*2
and use DeviceNet.
*2
and use Compo-
*1