Section 1 - Safety; General Safety Practices; Safety During Transport - KMC Controls 61 Series Manual

1.1 GENERAL SAFETY PRACTICES

All operators are to be instructed in the
•
safe and proper use of this machine and
must understand all safety decals as well
as instructions in this manual.
Carefully read all safety message in this
•
manual and on your machine.
Keep all safety signs in good condition.
•
Replace when necessary.
Find a spacious, clear, and level surface
•
to perform any maintenance or adjust-
ments.
Never work around running machinery.
•
Never remove obstructions from machin-
•
ery while still running.
DO NOT walk under the tool assembly
•
when the tools are elevated.
DO NOT ride on harrow frame.
•
Any damage/deterioration on any parts
•
should be repaired/replaced immediately
be the authorized personnel to reduce
the risk of personal injury.
Regularly check the condition of the U-
•
Bolts and bearing assemblies. Replace
any suspect parts to prevent accidents.

1.2 SAFETY DURING TRANSPORT

A) General
Use the safety pins provided for securing
•
the wings and the tail during transport.
See Safety locks in Section 1.4
Check that local road regulations are
•
adhered to when moving your harrow on
public roads.
section for dimensions and weight of
harrow.
Never transport the harrow over 80 km/
•
hour (50 miles/hour).
45' Rotary Harrow

SECTION 1 - SAFETY

Refer to Specifications
Be sure that your tow vehicle is properly
•
equipped and is capable of pulling the
harrow.
Always take precautions near overhead
•
electrical wires.
B) Extremity/Tail Lights
Extremity Lighting (Wing)
3 SEPT 2008