Commissioning; Maintenance; Inspection And Preventive Maintenance; Technical Information Relating To Inspection And Preventive Maintenance Work - Siemens ELP 319 Operating And Service Manual

11 Commissioning

After mounting of the ELP 319 end position detector, check that it functions perfectly by throwing the
points several times. A correspondence check must be carried out to see if the point position
corresponds to the detection indications in the interlocking.
The current regulations of the railway operator must be observed.
The parts of the end position detector must not be greased or oiled when putting it into service.

12 Maintenance

12.1 Inspection and Preventive Maintenance

Inspection includes a functional check, preventive maintenance the greasing and oiling of the parts of
the ELP 319 end position detector. Use the products listed in Section 7.5 to grease and oil the end
position detector parts.
12.2 Technical Information relating to Inspection and Preventive Maintenance
Work
By performing the inspection and preventive maintenance work in the intervals prescribed, the
functional integrity of the ELP 319 end position detector in maintained even under extreme operating
conditions.
The ELP 319 end position detector requires little maintenance. All the bearing surfaces remain
operational, even if they have not been re-lubricated for a long time. The end position detector is
insensitive to oil and grease in the housing.
The limit switches of the two contact arrangements are maintenance-free. Dimensions and material
combinations of the remaining movable components have been so chosen that, when sufficiently
lubricated, long intervals between maintenance can be attained.
Betriebsanleitung
[7620] ELP 319
DC013
Copyright (C) Siemens AG 1998
PZENTW A6Z08101637795/EN1/000/B
LANGE_THO A25000-X22-Q9-7-7620
20081022 Notice no.: 500000097465
All Rights Reserved -
Industry Mobility
28
of
33
0000ZQ6U.doc