Table of Contents
Advertisement
ETC Installation Guide
ColorSource Spot jr v2.0/v3.0
Re-record Presets
1. Using DMX, set the desired levels for the new preset.
2. Press the Mode button to access the Presets/Sequences menu.
3. Press the Up button or Down button to navigate to the preset number
that you want to re-record.
4. Press and hold the Mode button for 3 seconds to confirm the preset
selection. The user interface will show a 3-second countdown. The preset
number blinks once to confirm that the preset has been recorded.
Note:
1ch
(
), you cannot re-record presets.
When you re-record presets with the fixture in RGB mode (
intensity is set to full and the strobe is turned off.
See
Change the DMX Control Mode on
Adjust the Intensity of Presets
1. Ensure that DMX data is not present.
2. Press the Mode button to access the Presets/Sequences menu, and then
press the Up button or Down button to select the preset that you want to
edit.
3. Press and hold the Mode button for 3 seconds. The display shows
followed by either an intensity level from
4. Press the Up button or Down button to change the intensity level of the
preset in real time.
5. Press the Mode button to confirm your selection and return to
the Presets/Sequences menu.
The display will automatically return to the Presets/Sequences menu after
10 seconds of inactivity, and edits to the preset intensity will not be saved.
ColorSource Spot jr
When the fixture is in Direct mode (
dir
) or 1-channel mode
page 6.
0– 99
Page 9 of 16
rgb
), the
FL
or
for full.
L:
ETC
Advertisement
Table of Contents
Need help?
Do you have a question about the ColorSource Spot jr v2.0 and is the answer not in the manual?
Questions and answers