NeoLight Skylife Service Manual page 29

3. Then press on the "gear"
button to go to settings
4. Here, you will find the Light Module Hours shown as LM1 and LM2 and the firmware version
number.
5. Record LM1 and LM2 in the designated box in the Service Guide
6. You may use the sheet provided Appendices A & B for this purpose. Ensure to start a new sheet after
replacing Light Modules.
NOTE If any errors arise during this process, proceed to **(Troubleshooting Section) * for
further instructions.
4.7 Packaging Instructions for Skylife Carrying and Travel Cases
NOTE This procedure applies to both the Skylife Carrying Case (SKY-CAS) and Skylife travel
Case (SKY-TRV)
1. Open out the case on a
sufficiently large work
surface. Place it so that
the long side is facing you.
2. Place the accessories in
the slot shown.
© 2022 by NeoLight LLC.
All rights reserved.
Page 29 of 43
500050 Rev A