NeoLight Skylife Service Manual page 21

CAUTION:
The Skylife Disposable Swaddles protect the GelMat, and Light Bed from contamination
during use. If bodily fluids soak through the Skylife Disposable Swaddles to the GelMat,
the GelMat may require cleaning. Do not remove the GelMat during cleaning.
CAUTION:
Do not immerse the Skylife or its accessories in liquid or clean with caustic or abrasive
cleaners. Likewise, do not spray or pour any liquid on the Skylife enclosure.
CAUTION:
Do not use iodine solutions, strongly acidic or alkaline solutions, and do not autoclave or
gas sterilize the Skylife system.
1. Remove the Skylife Disposable Swaddles from the device and discard. Skylife Disposable Swaddles
must be discarded between patients, if soiled or after 24 hours of use, whichever comes first.
Note: If you are using a single-patient-use Skylife mattress cover instead of Skylife Disposable
Swaddles, refer to its reprocessing instructions
2. Using recommended, pre-moistened disinfection wipes (such as Super Sani Cloth), remove all visible
contamination from the GelMat and verify under standard lighting.
3. After all visible contamination has been removed, use disinfection wipes to thoroughly wet the
exposed surfaces of the GelMat and edges of the Light Bed.
4. Ensure that the surface remains visibly wet for 3 minutes at room temperature (68°F/ 20°C) or as
specified by product instructions. Use additional wipes as needed to maintain a visibly damp surface.
5. Allow the surface to dry.
6. Follow this by using a clean damp cloth moistened only with clean water to rinse the exposed
surfaces. Repeat this at least 2 more times with a clean wet cloth or until any remaining chemical
residues are removed.
7. If the device is determined not to be visibly clean after these steps, repeat the cleaning process or do
not use the device (refer to section 5 to contact our customer service for further instructions).
© 2022 by NeoLight LLC.
All rights reserved.
Page 21 of 43
500050 Rev A