Simplex 4010ES Operator's Manual page 29

Report
TrueAlert Status Report
TrueAlarm CO Report
Install Mode List Report
Alarm Verification Tally Report
TrueAlert ES Self-Test Report
Procedure:
1. Press the Menu key. Use the Next and Previous keys to scroll through the choices until the PRINT REPORTS? choice is
displayed.
2. Use the Next and Previous keys to scroll through the categories of report (Alarm History, Trouble History, etc.).
3. When the category of report you want to print is displayed, press ENTER. The system prompts you to confirm that you want to
generate the report. Press ENTER again.
page 27
Table 3: Reports
Description
This report can be created after the TrueNAC Voltage Drop Test (see
Drop Test) is run. It reports the following information for each Multi Candela TrueAlert
Device.
• Point ID.
• Custom Label.
• Pass/Fail.
Report the following information for each SLC
• Nominal Current (A) - The current draw on the TrueAlert circuit when the test was run.
• Worst Case Current (A) - The current draw on the SLC under worst case operating
conditions.
• Worst Case voltage Above/Below threshold (V).
This report provides the following information regarding the CO devices:
• Device Number (on the network).
• Custom Label (custom description of device).
• Current Device Value (PPM).
• End-of-Life Date.
• Device Status (Normal, Trouble).
This report porvides the following information regarding the Install Mode list:
• Point ID.
• Custom Label.
• Device Status.
This report provides the following information for each device supporting alarm verification:
• Device Number.
• Custom Label.
• Device Type.
• Point Type.
• Tally Count.
This report provides the following information for devices that support Self-Test:
• Point ID.
• Custom label.
• Test date.
• Self-Test result.
4010ES Fire Alarm Operator's Manual
TrueNAC Voltage
579-969 Rev E