Advanced Functions; Logging In And Out Of The System; Log In Procedure - Simplex 4010ES Operator's Manual

8 Advanced functions

This section describes advanced functions that you can perform from the operator interface panel.
8.1

Logging in and out of the system

The 4010ES system uses four access levels, referred to by the numbers one through four, to control what system operators can do
with the system. The system typically operates at access level one, which allows an operator to accomplish basic tasks (for example,
acknowledge alarm, trouble, and supervisory conditions) without logging in to the system.
Other functions – for example, the use of the user-defined function keys – are passcode protected to prevent access by unauthorized
personnel.
8.1.1

Log in procedure

Follow these steps to log in to the system at access level two, three, or four. The keypad used to enter the passcode is located behind the
interface panel access door.
1. Obtain the passcode for the access level at which you want to operate.
Press the Menu key. The alphanumeric display shows the following message.
2.
Press the ENTER key on the entry keypad. The following message displays:
3.
Press the 1 key on the entry keypad. The display shows the following message.
4.
Enter the passcode for the access level. The passcode can be up to 10 numbers in length. Press the ENTER key on the entry
5.
keypad when you have finished entering the code. An X is displayed for each digit of your passcode, as shown below.
If the passcode entered in Step 5 is correct, the following message is shown.
After a brief pause, the system displays the granted access level, such as the level 2 message shown below.
page 23
4010ES Fire Alarm Operator's Manual
579-969 Rev E