Selecting Points - Simplex 4010ES Operator's Manual

6.3.1

Selecting Points

Refer to the following table for information on using the keypad to select local points on this panel.
Key
ZONE - allows you to select a Monitor Zone point. ZN, followed by ENTER, where ZN represents a zone card and is a number from 1 to n.
SIG - allows you to select a Signal point.
AUX - allows you to select an Auxiliary Relay.
FB – allows you to select a Feedback point.
IO - allows you to select a point on a 24 Point I/O
card.
page 18
Figure 4: Entry Keypad
Table 2: Keypad Use
Data to Enter
(n represents the number of the last zone card in your system.) After selecting a zone,
use Next and Previous to scroll through the points.
SIG, followed by ENTER, where SIG represents a signal card and is number from 3 to n.
(n represents the number of the last signal card in your system.) After selecting a signal
card, use Next and Previous to scroll through the signal points.
SIG, followed by ENTER, where SIG represents an
IDNAC symbolic channel then "-" and the NXNA point number on that channel.
AUX, followed by ENTER, where AUX represents an auxiliary relay and is a number from
3 to n. (n represents the number of the last auxiliary relay in your system.)
Enter the number corresponding to the Feedback point. For example, pressing the
FBkey and entering a 1 selects FB1.
IO, followed by ENTER, where IO represents a point and is a number from 1 to n. (n
represents the number of the last I/O point in your system.
4010ES Fire Alarm Operator's Manual
579-969 Rev E