Turning On The Camera - Ricoh RDC-5300 Operation Manual

Turning on the Camera

Slide the power switch to turn the camera on and slide the switch again to turn it off.
q Slide the center button of power switch
to on.
The camera will turn on and the monitor cover
will open.
• The lens barrier will not open, even if
Note
the power switch is operated, when in
a playback mode other than record or
in the erase mode.
• Sliding the power switch again will turn
off the power. And the lens barrier and
monitor cover will open.
w Set the mode dial to [
The LCD panel or the LCD monitor will display
recording information.
LCD Monitor Display
Press the DISPLAY button to switch displays
appearing on the LCD monitor. If the LCD monitor
is not used, press the DISPLAY button to save the
batteries. Press the DISPLAY button again to
enable the LCD monitor.
You may set the camera to come up with the LCD
monitor disabled when it is powered on. See
"Changing the LCD Setting" (p.109).
Using the DISPLAY button to turn the power on and off
The camera power can also be turned on and off by using the DISPLAY button. When
the DISPLAY button is pressed for 2 sec. or more with the mode dial set to [
power will be turned on. Pressing the DISPLAY button again will turn the power off.
Set the DISPLAY button beforehand. See "Using the DISPLAY Button to Turn the
Power On and Off". (p.112)
].
2
１２
１８００×１２００ Ｎ
], the
41