Table of Contents
Advertisement
Using the Remote Control
The DR-3 remote control unit (optional) makes it possible to record and play back
images from a remote location.
Important
• The remote control receiver is located on the right side of the lens.
Note
Operate the remote control unit by pointing it at the remote control
receiver.
Note
• For instructions on replacing the batteries and maintaining the remote
control unit, refer to the accompanying manual.
• Some procedures differ when performed on the remote control unit and
on the camera itself. Follow the instructions below to use the remote
control unit.
Shooting
The remote control unit can be used to operate the camera. It is particularly
convenient when the camera is set up at a remote location or is in a fixed position.
q Set the mode dial to [
CARD/IN button to select a recording
destination.
w Decide the composition of the picture
and press the RELEASE button on the
remote control unit.
When the camera is set to the Still mode, the
self-timer lamp will blink and recording will start
approximately 2 sec. later. In the Continuous
mode, recording will start immediately after the
RELEASE button is pressed.
Note
• Use the zoom buttons to vary the size
of the subject. The
magnifies the subject (telephoto), while
the
the subject (wide angle).
114
] and press the
button
button decreases the size of
R E L E ASE
ERASE
F WD
PROGR AM
E V
ENTER
RE V
MULTI
Advertisement
Table of Contents
