Initial Settings; Turning The Camera On - Ricoh GR III Operating Manual

Turn the camera on and make the initial settings.
1
2
40
e_kb588_om.indb 40

Initial Settings

Turning the Camera On

Press the power button.
The power button lamp lights, and then the
status lamp blinks for several seconds.
The first time the camera is turned on after
purchase, the [Language/H] screen ap-
pears.
When the power button is pressed again, the
power turns off.
Turning the Camera On in the Playback Mode --------------------------------------------------------
• When g is pressed and held with the camera turned off, the camera turns on in the playback mode.
The following operations are available.
g
Press z halfway
Turning the Camera On with the Wi-Fi Function Enabled ------------------------------------------
• When g is pressed and held with the camera turned off until a beep sounds, the camera turns on
with the Wi-Fi function enabled. (p.115)
• When the Wi-Fi function is enabled using g, the camera is not switched to the shooting mode even
if z is pressed. When performing shooting or other operations, press g to turn the camera
off and press the power button to turn the camera back on.
Memo ---------------------------------------------------------------------------------------------------------
• The power button lamp can be set to [Off] in [Power Button Lamp] of the E4 menu. (p.129)
• If no operations are made for approximately one minute, the camera turns off automatically to sup-
press battery drain. The power saving function can be set in the E7 menu. (p.130)
• The number of images taken on the day (except the deleted images) is displayed when the power
is turned off.
Turns off the power of the camera.
Switches the camera to the shooting mode.
2018/08/07 10:01:01