Table of Contents
Advertisement
Problem
Display shut off
Dead batteries
Auto power-off activated
Remote control
Obstruction between the remote
control unit and camera sensor
unit will not
work
Dirty remote control transmitter or
camera sensor
Dead remote control batteries
LCD monitor
Area captured by autofocus field
brightness
and the surrounding area have
changes during
contrasting light levels or the
autofocus
entire subject is dark.
operation
Phenomenon occurring with
Vertical lines
pictures of bright subjects, known
appear on
as the smudge phenomenon
image
Miscellaneous
Problem
SmartMedia
Wrong type of SmartMedia
memory card
memory card
will not fit into
SmartMedia memory card
slot
incorrectly oriented
Camera will not
Dead batteries
operate even
Camera malfunction
when buttons
and switches
are
manipulated
Date and time
Date and time setting is incorrect
are wrong
Battery removed
Date and time
were set but
disappeared
File won't erase
Camera not set to erase mode
or SmartMedia
Write protect pad on SmartMedia
memory card
memory card
won't format
File protected
Power switch off or auto power-
off activated.
Batteries have been removed
Mode settings
have changed
Auto power-off
Auto power-off setting is disabled
will not activate
Camera powered by AC adapter
(auto power-off is automatically
disabled when powered by an AC
adapter)
Beep will not
Beep disabled
sound
No image on
The video I/O switch is set on
the TV screen
[IN].
The television system setting is
incorrect.
The output video gear has an
incorrect video I/O switch setting.
Cause
Replace batteries.
Slide power on again.
Remove the obstruction. (Sensor is on
the left side of the lens.)
Clean with a soft dry cloth.
Replace CR2032 lithium batteries.
There is no malfunction.
There is no malfunction. Never shoot the
Sun, etc.
Cause
Use a SmartMedia memory card specified
for the camera.
Insert the SmartMedia memory card the
correct way.
Replace batteries.
Slide the power off and on once. Turn the
mode dial to [
persists, (1) reset the camera by sliding
the power switch after removing the main
batteries, and (2) reinstall the batteries
and try to operate the camera again.
Reset the date and time.
The date setting is reset if the battery has
been removed for about 3 minutes or
longer. Set the date again.
Turn the mode dial to [
Remove pad from SmartMedia memory
card.
Use the play menu to reset the file's
protection setting.
Slide power on and retry.
Reset mode.
Enable setting.
Set beep sound to [ON] on the SETUP
menu.
Set video I/O switch is set on [OUT].
Select the correct television system.
Check to see if the output video gear has
a correct video I/O switch setting.
Solution
Solution
] or [
]. If the problem
].
–
Page
27
41
–
–
–
–
–
Page
32
32
27
–
5
35
35
94
31
83, 91
103
102
103
–
102
77
107
–
123
Advertisement
Table of Contents
