Changing File Names; Changing File Names - Ricoh RDC-5300 Operation Manual

Ricoh digital camera operation manual model number: rdc-5300
Hide thumbs Also See for RDC-5300:
Table of Contents

Advertisement

Changing File Names

When SmartMedia is being used for recording, sequential numbers are assigned as
the file names. When a file name other than a sequential number is preferred for each
SmartMedia, change the setting as follows.
With sequential numbering on (initial setting)
The file names R001 0001 to R999 9999 are assigned to the files.
Since the camera remembers the last file name assigned, the numbers will still be
assigned in sequence, even when a new SmartMedia is used.
If the SmartMedia contains a number larger than the last file name remembered by the
camera, however, the numbers assigned will continue from the last number in the
SmartMedia.
* Continuous file names will be assigned even when a different SmartMedia is loaded. There is
no duplication of file names.
* The file names within one SmartMedia may not be continuous in some cases.
* To reset the numbers, initialize the setting (page 110) and load a SmartMedia containing no
images.
When continuous numbering is off
The file names RIMG0001 to RIMG9999 will be assigned to the files.
When a new SmartMedia is loaded, the file names will be assigned in sequence,
starting with RIMG0001. If a full SmartMedia is loaded, the consecutive numbers in the
SmartMedia will be assigned.
* File names are assigned starting with RIMG0001 for each SmartMedia.
* When the file name becomes RIMG9999, "FILE NUMBER OVER" will be displayed. (p.13)
Note
• It is only possible to set whether or not consecutive numbers are to be
used as file names when a SmartMedia is used. In the case of built-in
memory, file names will be assigned starting with RIMG0001.
• Using consecutive numbering for file names prevents is recommended
when the images are to be used on a personal computer or in conjunction
with a digital print service.
• To reset the numbers to zero (0), either initialize the setting or load a
smart media containing no images.
q Set the MODE dial to [
The SETUP menu will appear.
• Rotate the MODE dial to cancel the
Note
operation.
].
5
111

Advertisement

Table of Contents
loading

Table of Contents