Table of Contents
Advertisement
Note
• A flashing AF indication LED indicates that the subject is out of focus. If
this occurs, use the focus lock function. See "Focus Lock Shooting" (p.62).
• If the "SLOW SHUTTER" message appears on the LCD monitor, you are
recommended to shoot with the flash enabled or in S mode to avoid
camera shake that tends to occur in this situation. See "Changing Flash
Modes" (p.55) and "S Mode (Shutter Speed)" (p.71).
r Press the shutter release button down
fully without removing your finger.
A beep will sound and the picture will be taken.
Note
• If the camera is moved before the
buzzer sounds, blurring may occur.
• If recording fails, the buzzer will
produce a beeping sound. In such
cases, take the photograph again.
Quick shooting mode [
As long as the release button is pressed, frames will be photographed at the rate of
approximately one frame per second. The photographed images are temporarily
saved to the memory inside the camera and are then recorded when picture taking
is completed.
Picture taking stops when the finger is removed from the release button. The
images photographed up to that point are temporarily saved to the memory inside
the camera. When the release button is again pressed, the remaining frames will
be exposed. The images stored inside the camera are recorded when the following
occur.
• When the MENU button, PIC button or CARD/IN button is pressed
• When the mode dial is rotated
• When the power is turned off (AF lamp and flash lamp blinking)
When there is no operation for 30 sec. after an exposure is made
• When the number of frames remaining is zero (0)/when all frames have been
exposed
• When the [
] mark appears on the LCD monitor
Still frame mode (
When the release button is fully pressed, a photograph is taken and recorded.
When set for the image to appear on the LCD monitor, the image will first be
displayed and then recorded. Recording can be started immediately by pressing
the ▼ or ▲ button. See "Changing LCD Confirmation".
While the image is being displayed on the LCD
monitor, recording can be canceled by pressing
the MENU button. Messages are displayed
during recording, so press the ENTER button.
]
)/text mode (
)
A B O R T
R E C O R D I N G
A B O R T
:
E N T E R
C A N C E L :
M E N U
2
49
Advertisement
Table of Contents
