Initial Settings; Turning The Camera On - Ricoh R02010 Operating Manual

Initial Settings

Turn the camera on and make the initial settings.

Turning the Camera On

1
2
Press the power button.
The power button lamp lights, and then the
status lamp blinks for several seconds.
The first time the camera is turned on after
purchase, the [Language/H] screen ap-
pears.
When the power button is pressed again, the
power turns off.
Turning the Camera On in the Playback Mode --------------------------------------------------------
• When g is pressed and held with the camera turned off, the camera turns on in the playback mode.
The following operations are available.
g
Press z halfway
Turning the Camera On with the Wireless LAN Function Enabled ---------------------------------
• When g is pressed and held with the camera turned off until a beep sounds, the camera turns on
in the playback mode with the wireless LAN function enabled. (p.115)
• When the wireless LAN function is enabled using g, the camera is not switched to the shooting
mode even if z is pressed. When performing shooting or other operations, press g to turn
the camera off and press the power button to turn the camera back on.
Memo ---------------------------------------------------------------------------------------------------------
• The power button lamp can be set to [Off] in [Power Button Lamp] of the E4 menu. (p.129)
• If no operations are made for about one minute (default setting), the camera turns off automatically
to suppress battery drain. The power saving function can be set in the E7 menu. (p.131)
• The number of images taken on the day (except the deleted images) is displayed when the power
is turned off.
40
Turns off the power of the camera.
Switches the camera to the shooting mode.