Creating A New Project Workspace; Preparing For Creating A New Project Workspace; Procedure For Creating A New Project Workspace - Renesas M3A-HS71 Installation Manual

Cpu board renesas 32-bit risc microcomputers superh risc engine family/sh7670 series

Hide thumbs Also See for M3A-HS71:

Table of Contents

5.1 Creating a New Project Workspace

The following explanation describes how to create a new project workspace suitable for the SH7670 CPU board.

The procedure for creating a load module from a new project workspace and then downloading and running the

module in the flash memory connected external to the SH7670 CPU board are described as the below.

Copy "Sample_software" directory from the CD-ROM into the working directory of the host computer. When the

"Sample_software" directory has the read-only attribute, remove its read-only attribute. Make sure the directory path to

which this directory is copied does not include kanji and space characters. Presence of such characters makes the

cross tools unable to operate normally.

The explanation below assumes that this directory has been copied to the "C:¥WorkSpace¥sample_software"

Note: To create a new project workspace, the HEW, E10A-USB emulator software, and SuperH RISC engine C/C++

compiler must be installed in the host computer.

(1) Connect the host computer and the E10A-USB emulator.

(2) Connect the SH7670 CPU board and the E10A-USB emulator. (Do not turn on the power for the SH7670 CPU board

yet.)

(3) From [All Programs] on [Start] menu, choose [Renesas High-performance Embedded Workshop]

[High-performance Embedded Workshop].

(4) [Welcome] dialog box shown below will be displayed.

(5) In this dialog box, select the option "Create a New Project Workspace" and click "OK".

Rev. 1.01 May 7, 2008

REJ11J0015-0101

Creating and Running a New Project Workspace

Figure 5.1.1 Welcome Dialog Box

5.1 Creating a New Project Workspace

5-2

Table of Contents

Sh7670