4
(2) Specifying the command batch file before downloading
Next, you need to run the script file (fmtool_hs71.hdc) in which the access timing and bus control signal settings are
written in the flash memory of the SH7670 CPU board before downloading the sample software.
In the sample workspace, the following script file is assumed to be stored in.
" C: WorkSpace¥Sample_software¥SH7670_sample¥ fmtool_hs71"
Open [Debug] menu
shown below.
Command batch file load timing: Before download of modules
Command line batch processing:
"C: ¥WorkSpace¥ Sample_software¥sh7670_sample¥fmtool_hs71¥ fmtool_hs71.hdc"
(3) Activating the command line window
When downloading the load module of the sample software, you need to activate [Command Line] window to check
whether the script file is running.
Select [View] menu
Note: Unless the script file is running, you cannot download the load module into the flash memory. So be sure to check
this.
Rev. 1.01 May 7, 2008
REJ11J0015-0101
[Debug Settings], and select [Option] tab. Check to see that the items on this tab are set as
Figure4.1.16 Debug Settings Dialog Box
[Command Line] to check whether [Command Line] window is open.
Running the Software
4.1.4 Sample Software Download Procedure
4-9