3
(3) Press "Setup"(Figure3.2.9). The dialog box shown below will be displayed.
(4) Set the emulator setup switch (SW1) to the "0" side, and temporarily remove the USB cable and plug it in back again.
Then click "OK". The system will start setting up the E10A-USB emulator firmware.
•
Do not turn off the power for the host computer or remove the USB cable while the system is
setting up the E10A-USB emulator. Such an act may cause the E10A-USB emulator to break
down.
(5) When the dialog box shown below is displayed, it means that the system has finished setting up the E10A-USB
emulator normally.
Rev. 1.01 May 7, 2008
REJ11J0015-0101
Figure3.2.12 Setup Tool for SHxxxx E10A-USB Emulator Dialog Box
Figure3.2.13 System Starts Setting Up the Firmware
Figure3.2.14 Setup Completion Message
3.2.2 Setting Up the E10A-USB Emulator
CAUTION
Setting Up the Software
3-12