3
(1) Open the slide switch cover on the E10A-USB emulator main unit, and check to see that the emulator setup switch
(SW1) is set to the "1" side.
(2) From [All Programs] on [Start menu], choose [Renesas High-performance Embedded Workshop]
[Setup Tool for E10A-USB Emulator]
(a) Device group of the emulator firmware
(b) Version number of the emulator firmware
(c) Version number of the setup program
Note: The version numbers differ with each device group supported by the E10A-USB emulator.
Rev. 1.01 May 7, 2008
REJ11J0015-0101
[SH-2A Device Group]. An E10A-USB emulator setup tool will start up.
Figure3.2.9 E10A-USB Emulator Setup Tool
: Shows the product group name that is currently set up.
: Shows the version of the SH-2A group control software in the
E10A-USB emulator.
: Shows the version of the setup program.
Setting Up the Software
3.2.2 Setting Up the E10A-USB Emulator
(a)
(b)
(c)
3-10