Renesas M3A-HS71 Installation Manual page 39

Cpu board renesas 32-bit risc microcomputers superh risc engine family/sh7670 series

Hide thumbs Also See for M3A-HS71:

Table of Contents

(6) After the E10A-USB emulator setup is completed, the message shown below will be displayed.

Set the emulator setup switch (SW1) to the "1" side, and temporarily remove the USB cable and plug it in back again.

Then click "OK".

Note: Always make sure the emulator setup switch (SW1) remains in the "1" side unless the setup tool is used.

(7) The dialog box shown below will be displayed again, so check it to see that you now have the latest version of

firmware installed, and click "Exit". Then you've finished setting up new firmware.

Note: The version numbers differ with each device group supported by the E10A-USB emulator.

Rev. 1.01 May 7, 2008

REJ11J0015-0101

Figure3.2.15 Setup Tool for SH-2A E10A-USB Emulator Dialog Box

Figure3.2.16 E10A-USB Emulator Setup Tool at Completion

Setting Up the Software

3.2.2 Setting Up the E10A-USB Emulator

Version numbers

3-13

Table of Contents

Sh7670