Table of Contents
Advertisement
5.2
Hardware Setup when M3A-2152G52 in Use
5.2.1
M3A-2195 Power Supply Connection and Settings
The following shows how to set M3A-2195.
For more details, refer to M3A-2195 User's Manual.
Power to the M3A-2195 SDI Interface Board can be fed from either a 5V DC power supply (5V) or
a 12 DC power supply (6-12V). Use the included 5V or 12V power supply cables to connect
M3A-2195 and a corresponding DC power supply.
The Connecting when Feeding Power to the M3A-21 is shown in Figure 5.4
Feeding from 12V DC ( 6 - 12V )
Feeding from 5V DC ( 4.5 - 5.5V )
Jumper connector
When feeding from DC 12V(J3)
Figure 5.4 Connecting when Feeding Power to the M3A-2195
5.2.2
Connecting to Host PC
In order to control the M3A-2195 SDI Interface Board from M3S-KD32R installed in the host PC,
the host PC's LPT parallel port and the M3A-2195's J1 connector should be connected with the
parallel cable included in M3A-2195.
The Connecting the M3A-2195 and Host PC is shown in Figure 5.5
Figure 5.5 Connecting the M3A-2195 and Host PC
REJ10B0224-0310/Rev.3.10
or
3 JP1 1
Starter Kit User's Manual M3A-2152
M3A-2195
3 JP1 1
Jumper connector
When feeding from DC 5V(J4)
(set as default when shipped from
factory)
Settings of JP1
Mar. 2008
32176 Group
J3
JP1
J4
Page 14 of 83
Advertisement
Table of Contents
