5.2
Hardware Setup when the Evaluation Board by Itself in Use
5.2.1
M3A-2154 Evaluation Board Power Supply and Settings
The following shows how to set the M3A-2154 Evaluation Board.
Use a 5V DC power supply to feed power to the M3A-2154 Evaluation Board.
Use an included 5V power supply cable to connect the 5V DC power supply and CN2 connector
included with the M3A-2154 Evaluation Board.
The Connecting when Feeding Power to the M3A-2154 Evaluation Board is shown in Figure 5.4
Figure 5.4 Connecting when Feeding Power to the M3A-2154 Evaluation Board
5.2.2
M3A-2154 Power Supply
Connecting the 5V power supply with the included cable turns the M3A-2154 Evaluation Board
powered on.
By disconnecting it, the M3A-2154 Evaluation Board turns powered off.
REJ10B0223-0150/Rev.1.50
M3A-2154 evaluation board
CN2
Mar 2008
32185/32186/32192/32195/32196 Group
Starter Kit User's Manual M3A-2154G52B
4.75-5.25V DC power supply
Page 12 of 80