RayTek 3i Operator's Manual page 30

To recall values from the LOG loop, do the following:
1. Release or unlock the trigger, if necessary.
2. Press the RECALL button. The RCL icon will be activated.
3. Press the RUN/LOG button, if necessary, so that the LOG icon is activated.
4. Read the recalled temperature from the display.
5. Press the or buttons (LOC mode) to recall values from other LOG locations.
RECALL contains two modes: LOC (location) and MAX (as shown in Figure 2-9). In
RECALL, the stored temperature and emissivity setting along with either the location
number or MAX temperature can be displayed for each of the 100 LOG locations.
2-18 Raynger 3i Series Operator's Manual