Polycom SpectraLink 1725-36038-001 Administration Manual page 40

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
40
Gather information and open the sample file
Each handset must have a specific filename with the form of
SIP_xxxx.cfg where xxxx is as assigned to each individual user by
the system administrator (e.g. sip_3001.cfg or sip_JohnDoe.cfg).
Username requirements are: alphanumeric, no spaces, no
punctuation, case is ignored, 1-16 characters.
The sample cfg files are populated with commonly-used values.
Consult the SIP Proxy Server Command Table in Appendix B for
detailed information on configuration options.
The specific file should contain data specific to each user such as
authentication credentials and line appearance data. See Chapter 5
Configure Each SpectraLink 8020/8030 Wireless Telephone, section
The Admin Menu, subsection
1. Gather the following information:
− username and password for this handset;
dial number for this line;
−
number of proxy server for this phone;
−
− data that should appear on the caller ID at the far end of a call;
− Favorites required for each handset/user, if any.
2. Retrieve the SIP_xxxx.cfg file from the .zip.
3. PROXYn settings: These should match the allusers settings
except if a specific handset needs an override.
4. Enter the username and password at # AUTH =.
Authentication credentials are normally not stored in the file for
security reasons, but the option is available if desired.
For lines on proxies of type NECSIP and SHORETEL the LINEn
AUTH setting should be used instead as each NEC or SHORETEL
line must respond to any authentication challenge using a single
UN/PW pair.
Enter specific line definitions
Each handset may have several lines. These would be labeled as
LINE1, LINE2, LINE3 and so forth as shown in the sample .cfg file in
Appendix C.
SIP Registration.
PN: 1725-36038-001_N.docx