Figure 18: Interval Tab In Tracking Profile Window With Standard And Motion Tabs - Iridium NAL SHOUT ns User Manual

Figure 18: Interval Tab in Tracking Profile Window with Standard and Motion Tabs

 Use Alternate Interval for Motion: When this setting is set to Yes, the SHOUT ns uses
alternate Time Between Reports, Time To Keep Trying, and Delayed First Report settings
while in motion. To set these alternate settings, use the Motion tab that appears when
Yes is selected.
o The AT command associated with this setting is ^UAMS.
 Time Between Reports (Standard and Motion): Sets the interval between tracking
report cycles. The interval can range from 0 and 10080 minutes in increments of 0.5
minutes (i.e., 30 seconds).
o The AT command associated with this setting is ^TBR (Standard) and ^TBRA
(Motion).
 Time To Keep Trying (Standard and Motion): Sets the duration in which the SHOUT ns
attempts to retry sending a tracking report. During a report cycle, the SHOUT ns
attempts to acquire a valid GPS fix and acceptable communication link signal strength.
Once the GPS fix and signal strength requirements are met, the device sends a report. If
the report fails to send, the SHOUT ns retries until the specified Time To Keep Trying
window expires.
o There are two additional special values for Time To Keep Trying: Only Once and
Until Next Report.
Document Number: 451-01037-001D
SHOUT ns/nsx User Guide Version D
52 of 91