Iridium NAL SHOUT ns User Manual page 47

 Startup Information: Hides/shows the text displayed when the device is turned on
(copyright, model number, etc.), which is echoed to the SHOUT ns device's USB serial
port.
o The AT command associated with this setting is ^SSI.
 Bluetooth Power: Sets whether the Bluetooth transceiver is turned on when the device
is turned on.
o The AT command associated with this setting is ^BTPWR.
 Normal Tracking Profile: Selects the stored tracking profile to be used in normal
tracking mode.
o The AT command associated with this setting is ^TPN.
 Emergency Tracking Profile: Selects the stored tracking profile to be used in emergency
tracking mode.
o The AT command associated with this setting is ^TPE.
 Power Up Time Refresh Frequency: When a power-up delay is set, the SHOUT ns
periodically wakes up from sleep to adjust its internal clock against the GPS receiver
timing signal. If the GPS receiver does not yet have a time fix, the SHOUT ns stays
awake for a specified period of time (Allowed GPS Acquisition Time) waiting for a GPS
time fix. After which, the SHOUT ns sleeps for another period of time (Power Up Time
Refresh Frequency) before retrying to find a time fix.
o These values are configured through the AT command ^PUPT.
 Remote Update Time Check: Enables a time check for incoming remote updates. When
enabled, remote updates with a timestamp less than or equal to the last remote
update time are not applied.
o The associated AT command is ^RUTC.
5.2.2.2 T
RACKING
This section covers the configuration tabs associated with the tracking profile settings.
1. Select Options > Configure Window.
2. Select Tracking Profile for the Profile Type at the top-left of the window.
3. Select the Store Profile number (see Figure 16).
Document Number: 451-01037-001D
P S
ROFILE ETTINGS
SHOUT ns/nsx User Guide Version D
47 of 91