Table of Contents
Advertisement
3.3
C
D
HARGE
The SHOUT ns is shipped with a partially charged battery. Before use, charge the SHOUT ns for
one hour.
Note: Upon battery depletion, the SHOUT ns should reach full charge within 2 hours of being
continuously plugged in.
Plug the wall charger into a 115 VAC power source. Confirm that when the wall charger is
plugged in and power is applied to the SHOUT ns USB port, the battery, GPS, Iridium, and status
LEDs blink in clockwise sequence for 3 seconds. Let the SHOUT ns charge for several hours or
until the BATT LED changes to steady illumination.
3.4
D
GPS R
EVICE
After charging the SHOUT ns, the device is ready to use. Hold the power button for 2 seconds.
The power LED and battery LED light up and the device begins functioning. Ensure the top of
the SHOUT ns has a clear view of the sky. The standard LED sequence during a successful report
is as follows:
1. The GPS LED lights first when a signal has been acquired.
2. The Iridium (IRDM) LED begins lighting when an Iridium signal has been acquired, either
solid or blinking based on signal strength.
3. The status (STAT) LED begins lighting when a report has been transmitted.
Once this has been accomplished, all LEDs turn off and the power LED blinks intermittently,
indicating the device is in sleep mode awaiting the next report transmission.
3.5
C
ONFIGURE THE
The SHOUT ns is shipped with the default settings below:
Report Rate: 5 minutes
Emergency Report Rate: 5 minutes
Transmit Report Without GPS Fix: Yes
Message Format: NAL Message Format
Document Number: 451-01037-001D
EVICE
ECEPTION AND
SHOUT
NS WITH
SHOUT ns/nsx User Guide Version D
I
R
RIDIUM
EGISTRATION
S
T
AT
ERM
23 of 91
Advertisement
Table of Contents
