2.5
USB P
ORT
The USB connector on the SHOUT ns is a USB Micro-B receptacle located on the right of the
chassis, as shown in Figure 4. This connector has a rubber O-ring sealed cover required to
achieve the IP67 rating of the device. The USB connector pin assignments are detailed below in
Table 2.
Table 2: Pin Assignments for the SHOUT ns USB Connector
Pin #
1
VBUS
2
USBD-
3
USBD+
4
ID
5
GND
Important: Ensure the rubber O-ring sealing cover shown in Figure 4 is fully seated before
exposing the SHOUT ns to water.
2.5.1
USB D
ATA
The SHOUT ns communicates to computer equipment using the USB Micro-B port located on
the right side of the chassis (see Figure 4). The USB connection allows configuration of and data
collection from the SHOUT ns using NAL Research's defined AT commands and NAL's SatTerm
console window. These AT commands can be found in the manual "AT Commands for Model
SHOUT ns" [1]; also see section 4.2 Modes of Operation. NAL Research recommends using the
Document Number: 451-01037-001D
Figure 4: Position of USB Connector
Signal
Description
USB VBUS
USB data
USB data
USB OTG ID
Ground
SHOUT ns/nsx User Guide Version D
Interface
USB
I
USB
I/O
USB
I/O
USB
I/O
USB
--
In/Out
20 of 91