Figure 10: General Profile Window With Motion Tab - Iridium NAL SHOUT ns User Manual

 Failed reports are reports that are unable to send after the specified Time to
Keep Trying value (see section 5.2.2.2 Tracking Profile Settings).
o When the number of queued reports reaches its maximum number, the oldest
queued reports are overwritten.
o The AT command associated with this setting is ^ERQM.
5.2.2.1.2 M
OTION
The SHOUT ns has a built-in sensor that can reliably detect motion. The Motion tab, as shown in
Figure 10, provides ways to detect different motion characteristics without having to interpret
the raw motion sensor signals. Motion detection can be enabled or disabled through the
Motion Enabled option in the tracking profile (see section 5.2.2.2 Tracking Profile Settings).

Figure 10: General Profile Window with Motion Tab

When motion detection is enabled, the device monitors the motion sensor to detect when the
device is in motion. To detect the start of motion, an algorithm involving motion detection
windows is used. This algorithm succeeds to detect motion when a certain number of
contiguous windows are each satisfied by a minimum number of TTL pulses from the motion
Document Number: 451-01037-001D
T
AB
SHOUT ns/nsx User Guide Version D
40 of 91