Iridium NAL SHOUT ns User Manual page 42

o The AT command associated with this setting is ^MSB.
 Sensitivity: Specifies the minimum number of motion sensor TTL pulses that must be
detected in order to satisfy a single motion detection window for the motion detection
algorithm.
o The AT command associated with this setting is ^MSB.
 Window Duration: Specifies the duration of each motion detection window for the
motion detection algorithm. The AT command associated with this setting is ^MSB.
 Minutes of Calm to End Motion: Specifies the duration of calm needed in order for the
device to return to the motionless state.
o The AT command associated with this setting is ^MSE.
 Motion Sensor Wait: Specifies the duration of time to ignore the motion sensor
whenever the SHOUT ns goes to sleep. Once this time has elapsed, motion detection
begins again.
o The AT command associated with this setting is ^MSW.
 Motion Sensor Reporting: Determines whether to send a report when motion starts
and/or ends. For this setting to have an effect, it is required that the Motion Enabled
option is enabled.
o If the Report on Motion Start option is enabled, a NAL format GPS version 6 report
with short code 20 (GPS Report Version 6 Format [2]) will be transmitted when
motion starts.
o If the Report on Motion Stop option is enabled, a version 6 report with short code
21 will be transmitted when motion ends.
o The AT command associated with this setting is ^MSR.
5.2.2.1.3 LED T
AB
For applications where prolonging battery life is essential, the LEDs can be turned off using the
^LEDS AT command or the SatTerm LED tab (see Figure 13). The SHOUT ns is shipped with all
LEDs set to ON.
Document Number: 451-01037-001D
SHOUT ns/nsx User Guide Version D
42 of 91