Figure 19: Other Profile Window With Miscellaneous Tab - Iridium NAL SHOUT ns User Manual

Figure 19: Other Profile Window with Miscellaneous Tab

 Remote Update Password: An unattended SHOUT ns can be reconfigured without
requiring direct access to the device. All of the tracking profile parameters and most of
the general parameters can be configured via remote updates. This parameter sets the
required remote update password. The password entered must be eight characters in
length. All printable characters are allowed. The factory-set default password is
12345678 and there is no requirement to change this password.
o The AT command for this setting is ^RUP.
 Identifier in Reports: Sets an additional identifier of up to 50 characters that is included
in Type 3, Type 4, and Type 5 tracking reports. Keep the identifier short to reduce
airtime cost, especially when on the Iridium link.
o The AT command associated with this setting is ^ID.
 Power-up Delay: This parameter enables the power-up delay to a specified date and
time. The date and time format is as follows: YYYY/MM/DD HH:MM:SS (i.e.,
2012/11/30 12:54:23). When in tracking mode and immediately after power is applied
to the SHOUT ns, the device remains in a power-saving sleep mode until the user-
specified date and time. At which point, the device enters tracking mode.
o The AT command for this setting is ^PUPD.
Document Number: 451-01037-001D
SHOUT ns/nsx User Guide Version D
54 of 91