Quick Start User Guide; Device Preparation; Device Start-Up; Device Charging - Iridium SHOUT ns General Description Manual

4.0 QUICK START USER GUIDE

This quick start user guide provides an overview for the user to receive the SHOUT ns and
transition it to operational use.

4.1 Device Preparation

Prior to use of the SHOUT ns, airtime must first be purchased from NAL Research or from
any Iridium certified airtime reseller. The SHOUT ns IMEI number must be registered by an
airtime reseller to "point" to a Network Operations Center (NOC) server. This section covers
how the user can quickly set up the SHOUT ns as a tracking device.
Remove the SHOUT ns, the wall charger and the USB cable from the packaging. Remove
the SHOUT ns USB port cover (see Figure 4) and connect the USB cable USB micro port to
the SHOUT ns. Connect the USB-A connector to the wall charger.

4.2 Device Start-up

Activate the SHOUT ns by pressing the power button (
LED ( ) illuminates. The Power LED should remain steadily illuminated. The Battery LED
should then start blinking in a 1.25 sec On and 0.25 sec Off pattern to indicate the battery
requires charging. If the battery is blinking in a 0.125 sec On and 1.0 sec Off pattern, this
indicates the battery is at less than 20% charge and will take longer to fully charge.
NOTE: If the device is not used for 10 minutes, the SHOUT ns will enter sleep
mode and the Power LED will change to blinking once every 5 seconds to
indicate it is asleep. The SHOUT ns can be removed from the sleep mode by
pressing the Power button for two seconds.
Before charging the unit, test the Emergency / 911 Mode activation feature with the
following button press combination; Power, Bluetooth, Power, Bluetooth.
should enter the Emergency / 911 Activation mode and all six LEDs should start flashing once
per second to indicate this mode is active. To cancel this mode, hold the power button for
two seconds to shut the device off. Hold the power button again for two seconds to power
the device back on. Again confirm the Power LED should remain steadily illuminated and the
Battery LED begins to blink as described above.

4.3 Device Charging

The SHOUT ns is shipped with a partially charged battery. Before use, the SHOUT ns
should be charged for one hour.**
NAL Research Corporation (451-01001.B)
) for two seconds until the Power
The SHOUT ns
19