Module Programming; With Transponder Without Can - Directechs DB3 Installation Manual

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

With transponder without CAN

1
Wait until the LED turns ON solid red.
2
Insert the key in the ignition switch. The LED turns ON solid green.
Turn the key to the ON position. Press the programming button 5x to skip CAN. The LED turns
3
ON solid orange for 3 seconds then turns OFF.
4
The module is now programmed. Remove the key from the ignition barrel.
You have successfully completed the module programming sequence.
12
403.TL11 1.15 2004 Toyota Camry
©2022 VOXX•DEI LLC. All rights reserved.