Module Programming - Directechs DIRECTED DIRECTWIRE DB3 Installing Manual

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
Connect the 10-pin, 12-pin and 14-pin harnesses to DB3, then wait until the LED turns ON
1
solid red.
Wait 4 seconds before turning the ignition ON.
2
The LED flashes orange if an OEM remote starter is detected. Refer to "OEM remote starter
detection" for more information.
Press the Push-to-Start (PTS) button twice to turn the ignition ON. The LED turns ON solid
3
green for 3 seconds, then shuts OFF.
If the LED flashes orange, press the programming button 5 times. The LED turns ON solid
4
orange for 3 seconds to indicate the programming is completed. Otherwise, proceed to the
next step.
5
Press the PTS button once more to turn the ignition OFF.
You have successfully completed the module programming sequence.
11
403.TL6 2.26 2016 Toyota Corolla (Smart Key)
©2023 Directed. All rights