Segway SNARLER AT6 S Owner's Manual page 103

◆ Do not move the winch to assist in hauling heavy objects. It
is easy to overload and cause damage to the wire rope.
◆ Pay attention to the dangerous areas and stay away from
them during the operation. Dangerous areas are winch drum,
fairlead, wire rope, pulley block, hook and motor.
◆ When the winch is under load, do not approach or cross the
rope.
◆ When using the hoist to move the load, place the vehicle
transmission in neutral and apply brake of the vehicle and
plug all wheels with wedges. When the hoist is working, the
vehicle engine should be operated to fully charge the battery.
Never use the hoist with insufficient voltage.
◆ Never disconnect the power supply when there is a load on
the winch.
◆ After the operation, please release the load immediately, and
do not tighten the cable.
◆ Always stay away from ropes, hooks and winches.
◆ Check winches, ropes, hooks, and broken strands of worn
wires regularly. When handling the steel wire rope, please
wear thick leather gloves. Do not let the steel wire rope
slip over your hands. Check the steel rope before use. The
crushed, pinched, worn or kinked area has seriously reduced
the carrying capacity. The damaged steel wire rope should
be replaced. It must be re-wound under a load of about 100
pounds.
◆ The clutch should be disconnected first, and then the wire
rope should be pulled by the hook of the protective lever. Do
not pull the wire rope directly through the hook with your
fingers.
◆ Maintain the specified tension so that the cable can be
wound on the reel and re-rolled after the operation tight.
◆ Do not operate the winch under the influence of alcohol or
OPERATION OPERATION
95