Segway SNARLER AT6 S Owner's Manual page 102

OPERATION OPERATION
very hot, stop winch and let it cool for a few minutes.
◆ The rope end cannot bear the full load, and the rope must
rotate around the drum at least 5 laps.
◆ Avoid pulling the from extreme angles, as this will cause the
rope to be rolled on One end of the barrel and damage the
rope.
◆ Note that the rope-drawing capacity of the winch is the
maximum rope-drawing capacity of the first layer, only the
first the layer can only be pulled, do not operate the winch
with overload capacity.
◆ Never hook the rope back to itself, otherwise the rope will be
damaged. Use trunk protection protector.
◆ Before operation, make sure that the winch is firmly installed
on the vehicle or bracket.
◆ Before moving heavy objects, check the wire rope to prevent
kinks and uneven wire layers. The slack rope must be
properly tightened under a weight of about 200.46 pounds.
◆ When pulling the load, be sure to lay a blanket or protective
layer on the wire rope near the hook end. This will prevent the
possibility of breaking the wire rope and help prevent serious
injuries and damage.
94