Memory / Usb Port (5060); Usb Port Specifications; Saving / Recalling Values (Mem/Mr Button) - AEMC 5050 User Manual

5. MEMORY / USB PORT (5060)

5.1 USB PORT SPECIFICATIONS

The Baud Rate must be set to 9600. "Parallel" is not available.
This setting is carried out in the SET-UP menu (see §2.6.7).
Data format: 8 data bits, 1 stop bit, no parity, Xon / Xoff protocol.
RS-232: Connection to a PC or to a Parallel Printer (for meters without a
USB port)
Cable, PC RS-232, DB9 F/F 6ft Null Modem Cable
(for meters without USB port) ............................................................Cat. #2119.45
9-pin female connector
to Model 5060

5.2 SAVING / RECALLING VALUES (MEM/MR BUTTON)

NOTE: After replacing or completely discharging the battery,
the message "Memory OFF" appears when you try to save a
measurement in memory.
To be able to save your measurements, you will need to do the following:
1. Set the instrument to SET-UP.
2. Press the MEM button (the display shows "MEM All clr").
3. Press the MEM button for 2s (the display shows "MEM ALL FrEE")
4. Measurements are now ready to be saved.
First Function - MEM (Save)
Results can be recorded in the instrument's memory and stored along with
addresses defined by an object number (OBJ) and a test number (TEST).
An object represents a "box" where we can place 99 tests. Thus, an object
can represent a machine or an installation upon which a certain number of
measurements (insulation, resistance and continuity) are carried out.
1. When the button is pressed, the MEM symbol flashes and the small display
indicates the first free OBJ : TEST number (e.g. 02 : 01). The main display
indicates "FrEE."
• The OBJ number is the same as that of the last saved measurement, and
the TEST number goes up in increments of 1.
• It is always possible to modify OBJ : TEST with ► and .
Megohmmeter Models 5050 & 5060
2
3
5
2
3
5
9-pin female connector
to serial printer
31