Mitsubishi MELSEC-Q Series User Manual page 97

2
SYSTEM CONFIGURATION
(b) For the QnUDE(H)CPU
1
Memory card *
POINT
Memory card *
PC card adapter
* 1: Do not format the ATA card by other than GX Developer.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)
* 2: For writing into memory card by GX Developer and information on USB cables, refer to the
operating manual of the GX Developer.
* 3: The available version varies depending on the system configuration. (
* 4: Use the following Ethernet cables:
• 10BASE-T connection: Cables compliant with Ethernet standards, category 3 or higher (STP/
UTP cables)
• 100BASE-TX connection: Cables compliant with Ethernet standards, category 5 or higher (STP/
UTP cables (In an environment subject to electric noise, use shielded twisted pair (STP) cables.))
Diagram 2.27 Configuration of peripheral devices
For connection between the Motion CPU, PC CPU module or C Controller module
and peripheral in the multiple CPU system, refer to the manual of each CPU
module.
Universal model QCPU
1
PC(GX Developer, GX Configurator) *
2.2 Configuration of peripheral devices
Ethernet cable*
3
2
USB cable *
Section 2.3)
2
- 44
1
2
4
3
4
5
6
7
8