Mitsubishi Electric MELSERVO-J4 Instruction Manual page 66

3. SIGNALS AND WIRING
(3) Wiring CNP1, CNP2, and CNP3
Use the servo amplifier power supply connector for wiring CNP1, CNP2, and CNP3.
(a) Connector
Connector Receptacle assembly
CNP1 06JFAT-SAXGDK-HT10.5
CNP2 05JFAT-SAXGDK-HT7.5
CNP3 03JFAT-SAXGDK-HT10.5
POINT
For the wire sizes used for wiring, refer to section 9.6.
MR-J4-500A4(-RJ) or more do not have these connectors.
(Note)
CNP1
CNP2
CNP3
Note. A pin for preventing improper connection is inserted to N- of CNP1 connector.
Table 3.1 Connector and applicable wire
Size
AWG 16 to 14
Servo amplifier
Applicable wire
Insulator OD
3.9 mm or shorter
3 - 9
Stripped
Open tool
length [mm]
10 J-FAT-OT-XL
Manufa
cturer
JST