Mitsubishi Electric MELSERVO-J4 Instruction Manual page 36

1. FUNCTIONS AND CONFIGURATION
(c) MR-J4-500B4(-RJ)
The broken line area is the same as
MR-J4-200B4(-RJ) or less.
(6)
(3)
(Note)
(4)
(5)
(1)
(2)
(7)
Note. Lines for slots around the battery holder are omitted from the illustration.
POINT
The servo amplifier is shown without the front cover. For removal of the front
cover, refer to section 1.7.2 of "MR-J4-_B(-RJ) Servo Amplifier Instruction
Manual".
No. Name/Application
Control circuit terminal block (TE2)
(1)
Used to connect the control circuit power supply.
Main circuit terminal block (TE1)
(2)
Connect the input power supply.
Battery holder
(3)
Install the battery for absolute position data
backup.
(4) Rating plate
Regenerative option/power factor improving
reactor terminal block (TE3)
(5)
Used to connect a regenerative option and a
power factor improving DC reactor.
Charge lamp
(6) When the main circuit is charged, this will light.
While this lamp is lit, do not reconnect the cables.
Protective earth (PE) terminal
(7)
Grounding terminal
1 - 23
Detailed
explanation
Section 3.2
MR-J4-_B
section 12.4
Section 1.4
Section 3.2
Section 3.2