Mr-J4-_A4(-Rj); Input Power Supply Circuit - Mitsubishi Electric MELSERVO-J4 Instruction Manual

General-purpose ac servo servo amplifier
Hide thumbs Also See for MELSERVO-J4:
Table of Contents

Advertisement

3. SIGNALS AND WIRING

3.1 MR-J4-_A4(-RJ)

3.1.1 Input power supply circuit

CAUTION
Configure the wirings so that the main circuit power supply is shut off and SON (Servo-on) is turned off after
deceleration to a stop due to an alarm occurring, enabled servo forced stop, etc. A molded-case circuit
breaker (MCCB) must be used with the input cables of the main circuit power supply.
Always connect a magnetic contactor between the power supply and the main
circuit power supply (L1, L2, and L3) of the servo amplifier, in order to configure a
circuit that shuts down the power supply on the side of the servo amplifier's power
supply. If a magnetic contactor is not connected, continuous flow of a large
current may cause a fire when the servo amplifier malfunctions.
Use ALM (Malfunction) to switch main circuit power supply off. Not doing so may
cause a fire when a regenerative transistor malfunctions or the like may overheat
the regenerative resistor.
Check the servo amplifier model, and then input proper voltage to the servo
amplifier power supply. If input voltage exceeds the upper limit, the servo amplifier
will break down.
The servo amplifier has a built-in surge absorber (varistor) to reduce noise and to
suppress lightning surge. The varistor can break down due to its aged
deterioration. To prevent a fire, use a molded-case circuit breaker or fuse for input
power supply.
Connecting a servo motor for different axis to U, V, W, or CN2 of the servo
amplifier may cause a malfunction.
POINT
EM2 has the same function as EM1 in the torque control mode.
3 - 3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mr-j4-a4Mr-j4-a4-rjMr-j4b4Mr-j4b4-rj

Table of Contents