F Interface Connection; Connection To A Cage Clamp Type Terminal Block - Unipulse F156 Operation Manual

2-5. SI/F Interface Connection

2-5-1. Connection to a cage clamp type terminal block

Connect to the cage clamp type terminal block by using the included mini-screwdriver.
1. Unsheathe the electric wire to be connected 5 – 6mm, and twist its end to such an extent that
it will not become loose.
2. Firmly insert the screwdriver into the upper hole while slightly pushing it up.
3. Insert the electric wire into the right hole so as not to loosen its end.
4. Pull out the screwdriver.
5. Lightly pull the electric wire to make sure that it is securely clamped.
CAUTION
・ The electric wire connectable to the cage clamp type terminal block is 0.2
to 2.5mm
・ Do not attach a crimp contact to the end of the electric wire, or solder it.
・ To connect two or more electric wires, twist them together beforehand.
2
.
2.CONNECTION
11