4 Assembly
4.1 Assembly of wall mounting
Wall mounting
Wall mounting
8
Assembly
EN
If you would like to mount the case on the wall of a
vehicle, use wall mounting WM 15370 (see Section "9
Supply Schedule" on page 13).
If you would like to mount the case on the wall of a buil-
ding, use the appropriate wall mounting WM 15731 (see
Section "9 Supply Schedule" on page 13).
1. Mark the spots for the holes on the surface where you
WM 15370
want to fasten the case.
You can use the wall mounting as a stencil.
2. Drill the holes:
–
–
WM 15371
3. Screw the wall mounting tightly into place.
in vehicles: with a drill bit of 3 mm in diameter
in buildings: with an appropriate bit for the requi-
red dowel.